|
The voltage clamp is an experimental method used by electrophysiologists to measure the ion currents through the membranes of excitable cells, such as neurons, while holding the membrane voltage at a set level. A basic voltage clamp will iteratively measure the membrane potential, and then change the membrane potential (voltage) to a desired value by adding the necessary current. This "clamps" the cell membrane at a desired constant voltage, allowing the voltage clamp to record what currents are delivered. Because the currents applied to the cell must be equal to (and opposite in charge to) the current going across the cell membrane at the set voltage, the recorded currents indicate how the cell reacts to changes in membrane potential.〔Hernandez-Ochoa, E. O. and M. F. Schneider (2012). "Voltage clamp methods for the study of membrane currents and SR Ca2+ release in adult skeletal muscle fibres." ''Prog. Biophys. Mol. Biol'' 108(3): 98–118.〕 Cell membranes of excitable cells contain many different kinds of ion channels, some of which are voltage-gated. The voltage clamp allows the membrane voltage to be manipulated independently of the ionic currents, allowing the current-voltage relationships of membrane channels to be studied. ==History== The concept of the voltage clamp is attributed to Kenneth Cole and George Marmont in the spring of 1947.〔Andrew Huxley, 1996, "Kenneth Sterward Cole 1900 – 1984, A biographical Memoir" National Academy of Sciences. (Washington D.C.)〕 They inserted an internal electrode into the giant axon of a squid and began to apply a current. Cole discovered that it was possible to use two electrodes and a feedback circuit to keep the cell's membrane potential at a level set by the experimenter. Cole developed the voltage clamp technique before the era of microelectrodes, so his two electrodes consisted of fine wires twisted around an insulating rod. Because this type of electrode could be inserted into only the largest cells, early electrophysiological experiments were conducted almost exclusively on squid axons. Squids squirt jets of water when they need to move quickly, as when escaping a predator. To make this escape as fast as possible, they have an axon that can reach 1 mm in diameter (signals propagate more quickly down large axons). The squid giant axon was the first preparation that could be used to voltage clamp a transmembrane current, and it was the basis of Hodgkin and Huxley's pioneering experiments on the properties of the action potential.〔 Alan Hodgkin realized that, to understand ion flux across the membrane, it was necessary to eliminate differences in membrane potential. Using experiments with the voltage clamp, Hodgkin and Andrew Huxley published 5 papers in the summer of 1952 describing how ionic currents give rise to the action potential.〔Vandenberg, J. I. and S. G. Waxman (2012). "Hodgkin and Huxley and the basis for electrical signalling: a remarkable legacy still going strong." J. Physiol. (Oxford, U. K.) 590(11): 2569–2570.〕 The final paper proposed the Hodgkin–Huxley model which mathematically describes the action potential. The use of voltage clamps in their experiments to study and model the action potential in detail has laid the foundation for electrophysiology; for which they shared the 1963 Nobel Prize in Physiology or Medicine.〔 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Voltage clamp」の詳細全文を読む スポンサード リンク
|